The use of a Method for Structural Design of Ring-Girders used in Penstocks
Đã lưu trong:
| Nhiều tác giả: | , , |
|---|---|
| Định dạng: | artículo original |
| Trạng thái: | Versión publicada |
| Ngày xuất bản: | 2018 |
| Miêu tả: | The methodology that calculates the internal stresses on a penstock shell restrained by a rigid ring girder was developed since the 1930’s, however, its automatization has not been implemented by commercial use software due to its complexity. This projectintends to automate one methodology to calculate the internal stresses on a steel penstock shellrestrained bya ring-girder. A penstock under normal operation condition, this is apipe full of water under pressure, was analyzed. A calculating tool was produced using EXCEL 2016 and Mathcad 10, for calculating the internal stresseson the penstock’s ring girder cross sections. The tool doesn’t consider the earthquake loading conditions. |
| Quốc gia: | Portal de Revistas UCR |
| Tổ chức giáo dục: | Universidad de Costa Rica |
| Repositorio: | Portal de Revistas UCR |
| Ngôn ngữ: | Español |
| OAI Identifier: | oai:archivo.portal.ucr.ac.cr:article/30672 |
| Truy cập trực tuyến: | https://archivo.revistas.ucr.ac.cr/index.php/materiales/article/view/30672 |
| Từ khóa: | Tubería a presión expuesta acero viga-anillo combinaciones de cargas condición normal de operación esfuerzos internos programa Exposed penstock steel ring-girder load combinations normal operation condition internal stresses spreadsheet |